Skip to content

Clothing

Kusti Weaving: How a Kusti Is Made, from Wool to Finished Sacred Cord

Each stage of Kusti weaving, from spinning lamb's wool to cutting, bleaching and pressing the cord.

Title card: How a Kusti Is Made, Step by Step – From lamb's wool on a drop spindle to 72 threads on the jantar, cut, bleached
On this page
  1. What is a Kusti made from?
  2. Where does Kusti wool come from today?
  3. How is the wool spun into Kusti yarn?
  4. How is the warp set up on the jantar?
  5. How is the Kusti woven?
  6. When is the Kusti cut, and by whom?
  7. How is a Kusti finished after weaving?
  8. How long is a finished Kusti?
  9. Where can you see each stage photographed?
  10. Frequently asked questions

Kusti weaving starts with white lamb's wool. Women spin it on a drop spindle, ply two yarns into one, and weave that thread on a wooden hand-loom called the jantar into a hollow cord of 72 threads, set out in six strands of twelve. When the weaving is almost done, the cord has traditionally been lifted off the jantar and given to a priest for cutting and consecration. The weaver then turns the hollow cord inside out with a needle, plaits the loose ends into three tassels at each end, washes it, bleaches it over sulphur and presses it flat. This guide follows each stage as the Parzor Foundation photographed it among the weavers of Navsari, set against the older account in J.J. Modi's The Religious Ceremonies and Customs of the Parsees (1922). You'll also see the word spelt Kushti or Kasti.

TodayMon 16 Nov

શહેરેવર રોજ

Shehrevar Roj, Tir Mah · 1396 Y.Z.

Open the Parsi calendar →

What is a Kusti made from?

Lamb's wool is the standard material. Modi put it plainly: "The kusti is made up of lamb's wool." Encyclopaedia Iranica describes each strand as twelve white threads "of lamb's or, less frequently goat's, wool". Dr Shernaz Cama, director of the UNESCO Parzor project, names white lamb's wool or camel's hair, and adds that in India only sheep's wool is used to weave Kustis.

Cotton is where the sources part ways. Iranica, citing the Nērangestān, says cotton can be used as well. Cama writes that the cord is made "never from cotton or any other fibre". We set out both positions and don't take a side.

Practice varies between families and Agiaries; your family priest's guidance comes first.

Where does Kusti wool come from today?

Cama records that fine yarn now comes from Australia, in clean bundles called fara that don't shrink. Weavers also use pooni, wool sold as slivers that are processed and ready for spinning. Pooni shrinks considerably, Cama notes, so the weaver has to weave at least half a yard more to end up with the length she wants.

The Bombay Parsi Punchayet says on its own website that it distributes wool imported from Australia to Kusti weavers at subsidised rates.

How is the wool spun into Kusti yarn?

Spinning is called oon kantwanu. Parzor's exhibit Spinning the Kusti shows the women teasing the wool by pulling the locks apart with their fingers, then dividing it into pieces of about eight to ten inches. Each piece is spun into fine yarn on a chaaterdi, a wooden drop spindle of 8 to 10 inches. Modi calls the hand-spindle a châtri, and says the wool is combed first.

Next, two spun yarns are combined into durry. That yarn gets a double twist, val dewanu, on a bigger spindle, the chaaterdo, which has a thicker shaft and a wider whorl. Modi describes the same step: two threads are prepared on two spindles and "are then twisted into one".

Spinning decides the character of the finished cord. Cama notes that the spinner's skill sets the thickness of the Kusti. Thin Kustis are in high demand, and they need very fine yarn.

How is the warp set up on the jantar?

The warp is the set of lengthwise threads the Kusti is woven on. In Modi's account the twisted thread is "passed round the loom 72 times", so the warp holds 72 threads, grouped in six strands of twelve. Cama describes the same 72 warp threads stretched in a continuous circle. Modi, Cama and Iranica all link the 72 threads to the 72 chapters of the Yasna. What the Kusti means is a bigger subject, covered in our guide to the Parsi Kusti.

Parzor's exhibit Weaving the Kusti, photographed with the weavers of Navsari, shows the warping in order:

  1. The warp threads are stretched on the tan khuta, with 12 threads on each fork.
  2. Units of 12 threads go into the veesoon and are sealed with a stick called a sali.
  3. All six units end up locked in the veesoon, and sets of 12 threads are tied for the heald shafts.
  4. A khangu is placed between the warp threads.
  5. Once the warp is even, the gargari gives it tension, and the weaver makes the final adjustment on the jantar.

Modi notes that the jantar's ends can be moved, so the warp can be set to whatever length is needed. Each of these tools is described in our guide to the Kusti loom and tools.

How is the Kusti woven?

The jantar is a hand-loom. Cama writes that the weft, the naru, "is passed with one hand". Parzor's exhibit shows the weaver picking out 12 threads with the beater to form each heald shaft, with a loop on the sali to lift it. The yarn is beaten into place with the kateli, a comb-shaped wooden beater. It takes years of practice, Cama says, to master the force, or thok, needed while beating.

Small wooden table loom with white and coloured warp threads stretched across it
A table inkle loom, a small band loom, warped with white and coloured threads. Photo: Cynthia_M._Parkhill (talk) (Uploads), CC BY 3.0, via Wikimedia Commons.

Modi adds that a continuous thread is passed through each of the six strands as the weaving goes on. The woven cord is hollow, as both Modi and Cama describe it.

Modi called weaving the sacred thread the privilege of the women of the priestly class. The weavers themselves are the subject of who weaves Kustis, and how the skill is passed on is covered in learning to weave a Kusti.

When is the Kusti cut, and by whom?

The cord is cut before it is finished. Modi wrote that when about a foot of the threads is still to be woven, the whole thread comes off the loom, to be "handed to a priest to be cut and consecrated". Cama gives the same sequence: the finished weaving comes off the loom "in a complete loop" and goes to the priest to be cut and consecrated. Hamid Moein of the University of Liège, writing on the Rivayat manuscripts, also describes a new Kusti being blessed and cut by a priest in a ceremony.

The prayers and purity rules around this step are covered in purity rules and prayers while making a Kusti.

Practice varies between families and Agiaries; your family priest's guidance comes first.

How is a Kusti finished after weaving?

The order below follows Parzor's exhibit Weaving the Kusti. Cama's article lists some of these steps in a different order.

  1. Turning it inside out (kusti otlavanu). A needle goes into the hollow cord and is drawn carefully through its whole length to invert it. Cama calls this the most difficult part of Kusti weaving. Modi describes the same needle step, after which the weaver knits the remaining part of the thread by hand.
  2. Plaiting the ends. The loose ends, the lars, are divided and plaited, a step Cama calls lar guthvanu. On the finished Kusti they form three tassels at each end, with 24 threads in each tassel, according to both Iranica and Cama.
  3. Washing. The lars are washed with soap and water.
  4. Bleaching (dhupvanu). Sulphur sprinkled on heated coal bleaches the new Kusti, with an earthen vessel as a cover. Parzor also shows a small brass or copper vessel (pital or tamba) filled with ash or burning coal and wrapped in white muslin. The bleached Kusti dries in the sun.
  5. Flattening (patti parvani). The Kusti is flattened on a wooden cylinder, the sambhelu or sariya, for at least half a day, then placed between two wooden blocks to even it out. Cama says this "flattens it and gives it a permanent shape".

Modi's shorter account ends with the Kusti being "finally washed before being used".

How long is a finished Kusti?

Our two sources give different ranges:

SourceLength rangeNotes
---------
Dr Shernaz Cama, UNESCO ParzorThree yards to about six yardsThe average Kusti, four and a half yards, is called a "mapni kusti"
Bombay Parsi Punchayet (its own website)3½ to 7 gajReady Kustis it buys from Navsari and sells on a cost-to-cost basis

Length is set on the loom. Modi describes the jantar's movable ends being adjusted "to the length required", and Parzor shows the tan khuta being moved along the charavana hatha of the loom to get the warp length needed. If you simply need a Kusti to wear, see our page to buy a Parsi Kusti online.

Where can you see each stage photographed?

Parzor's two online exhibits on Google Arts & Culture, Spinning the Kusti and Weaving the Kusti, photograph the spinning, warping, weaving and finishing stages. For books and films on the craft, see books and films on Kusti weaving.

Frequently asked questions

How many threads are in a Kusti?

A Kusti has 72 threads. During weaving they are arranged as six strands of twelve. J.J. Modi describes the thread being passed round the loom 72 times, and Encyclopaedia Iranica gives the same count. At each end the strands are finished as three tassels of 24 threads, according to Iranica and Parzor's Shernaz Cama.

What happens to a Kusti after it is woven?

It comes off the loom in a complete loop and has traditionally gone to a priest to be cut and consecrated. The weaver then turns the hollow cord inside out with a needle, plaits the loose ends, washes and bleaches it over sulphur, and presses it flat between two wooden blocks.

Is a Kusti made of wool or cotton?

Lamb's wool is the usual material, and Shernaz Cama of Parzor says only sheep's wool is used in India. Sources differ on cotton. Encyclopaedia Iranica, citing the Nērangestān, says cotton can be used as well. Cama writes that a Kusti is never made from cotton. Your family priest can advise you.

Who cuts a new Kusti?

Traditionally a priest cuts and consecrates the new Kusti before it is finished. J.J. Modi's 1922 account, Shernaz Cama of UNESCO Parzor and a study by Hamid Moein of the University of Liège all describe the priest's role. After the cut, the weaver turns the cord inside out and finishes the tasselled ends.

How is a new Kusti bleached?

Bleaching is called dhupvanu. Parzor Foundation photographed weavers sprinkling sulphur on heated coal and covering the new Kusti with an earthen vessel. Another method uses a small brass or copper vessel of ash or burning coal, wrapped in white muslin. The bleached Kusti is then dried in the sun before pressing.

Is a Kusti hollow?

Yes. The 72 warp threads are stretched in a continuous circle on the jantar, and both J.J. Modi and Shernaz Cama describe the woven Kusti as hollow. The weaver passes a needle through the hollow cord to turn it inside out, a step Navsari weavers call kusti otlavanu, before plaiting the ends.

Share this article

Facebook